Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISLIGHTING AND HORNSFOG/DRIVING LAMPSERVICE AND REPAIRFRONT POSITION LAMP REPLACEMENT
2012 Chevrolet Express 2500 V8-4.8L
Front Position Lamp Replacement
2012 Chevrolet Express 2500 V8-4.8LSECTION Front Position Lamp Replacement
Front Position Lamp Replacement
Removal Procedure
1. Remove the screws holding the retaining ring to the headlamp housing assembly.
2. Remove the retaining ring from the position lamp.
3. Remove the headlamp capsule (1) from the position lamp.
4. Remove the bulb (4) and socket from the rubber grommet in the lamp capsule.
5. Push in on the side of the bulb (4) and turn the bulb 1/4 turn counterclockwise.
6. Remove the bulb (4) from the socket.
Installation Procedure
1. Install the bulb (4) to the socket.
2. Push in on the bulb (4) and turn 1/4 turn clockwise.
3. Install the bulb (4) and socket into the rubber grommet in the headlamp capsule (1).
4. Install the headlamp capsule (1) to the headlamp housing.
5. Install the retaining ring to the headlamp housing assembly.
Caution:
Refer to Fastener Caution Fastener Caution.
6. Install the screws to the retaining ring to the headlamp housing assembly and tighten to 1.5 Nm (13 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.