Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISLIGHTING AND HORNSCARGO LAMPSERVICE AND REPAIR
2012 Chevrolet Express 2500 V8-4.8L
Cargo Lamp: Service and Repair
2012 Chevrolet Express 2500 V8-4.8LSECTION Service and Repair
Cargo Lamp Replacement
Removal Procedure
1. Disconnect the electrical connector.
2. Using a plastic flat bladed tool, release the double sided tape that retains the light assembly to the vehicle.
Installation Procedure
1. Install the light assembly into the vehicle with double sided tape.
Important:
In order to insure a good replacement of new adhesive or of old adhesive, verify that the surface meets the following conditions:
* The temperature of the surface is approximately 24-41°C (80-105°F).
* The surface is clean.
* The surface is free of wax or of oily film.
2. Connect the electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.