Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Battery Negative Cable Disconnection and Connection (without Start/Stop System)
2012 Chevrolet Cruze L4-1.8LSECTION Battery Negative Cable Disconnection and Connection (without Start/Stop System)
Battery Negative Cable Disconnection and Connection (without Start/Stop System)
Removal Procedure
1. Turn on the radio and record all of the customer radio station presets.
2. Ensure that all lamps and accessories are turned off.
3. Turn the ignition OFF and remove the ignition key.
4. Remove the battery cover (1).
Warning: Refer to Battery Disconnect Warning Service Precautions.
5. Loosen the battery negative cable nut (2).
6. Remove the battery negative cable (1) from the battery.
Installation Procedure
1. Install the battery negative cable (1) to the battery.
Caution: Refer to Fastener Caution Fastener Caution.
2. Fasten the battery negative cable nut (2) and tighten the nut to 4.5 Nm (40 lb in).
3. Install the battery cover (1).
4. Insert the ignition key and turn the ignition to the ON position.
5. Program volatile memory. Refer to Volatile Memory Programming Testing and Inspection.
6. Program all of the customer's radio station presets and set the radio clock to the current time.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.