Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CRUZE L4-1.8LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTFUEL DELIVERY AND AIR INDUCTIONFUEL PUMPSERVICE AND REPAIRFUEL TANK FUEL PUMP MODULE REPLACEMENT
2012 Chevrolet Cruze L4-1.8L
Fuel Tank Fuel Pump Module Replacement
2012 Chevrolet Cruze L4-1.8LSECTION Fuel Tank Fuel Pump Module Replacement
Fuel Tank Fuel Pump Module Replacement (1.8L 2H0 and LUW)
Special Tools
CH-45722 - Fuel Sender Lock Ring Wrench
For equivalent regional tools, refer to Special Tools Tools and Equipment.
Removal Procedure
1. Remove the fuel tank. Refer to Fuel Tank Replacement Fuel Tank Replacement.
2. Disconnect the fuel tank vent pipe (1) and the fuel feed pipe (4) from the fuel tank fuel pump module (3).
3. Disconnect the fuel tank fuel pump module wiring harness (2) from the fuel tank fuel pump module (3).
4. Close the fuel feed pipe and the fuel tank vent feed pipe with suitable caps.
Note: Do NOT use impact tools. Significant force will be required to release the lock ring. The use of a hammer and screwdriver is not recommended. Secure the fuel tank in order to prevent fuel tank rotation.
5. Using the CH-45722 - wrench and a long breaker-bar, rotate the fuel pump module lock ring in a counterclockwise direction in order to unlock the lock ring.
6. Remove fuel tank fuel pump module lock ring (1).
Note: Lift the fuel tank fuel pump module up slightly.
7. Remove the fuel tank fuel pump module (2).
8. Remove and DISCARD the fuel pump module seal (3).
Installation Procedure
1. Install a NEW fuel tank module seal (3).
2. Install the fuel tank fuel pump module (2).
3. Install the fuel pump module lock ring (1).
4. Make sure that the fuel tank fuel pump module (2) align with the fuel tank line (1).
Note: Do NOT use impact tools. Significant force will be required to release the lock ring. The use of a hammer and screwdriver is not recommended. Secure the fuel tank in order to prevent fuel tank rotation.
5. Using the CH-45722 - wrench and a long breaker-bar, rotate the lock ring in a clockwise direction in order to lock the lock ring.
6. Connect the fuel tank fuel pump module wiring harness (2) to the fuel tank fuel pump module (3).
7. Remove the caps from the fuel feed pipe and the fuel tank vent feed pipe.
8. Connect the fuel tank vent pipe (1) and the fuel feed pipe (4) to the fuel tank fuel pump module (3).
9. Install the fuel tank. Refer to Fuel Tank Replacement Fuel Tank Replacement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.