Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CRUZE L4-1.8LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDISC BRAKE SYSTEMBRAKE PADTESTING AND INSPECTION
2012 Chevrolet Cruze L4-1.8L
Brake Pad: Testing and Inspection
2012 Chevrolet Cruze L4-1.8LSECTION Testing and Inspection
Brake Pad Inspection
Special Tools
CH-230-A - Disc Gauge
For equivalent regional tools, refer to Special Tools Tools and Equipment.
Warning: Refer to Brake Dust Warning Brake Dust Warning.
1. Remove brake pads. Refer to Front Disc Brake Pads Replacement Front Disc Brake Pads Replacement and/or Rear Disc Brake Pads Replacement Rear Disc Brake Pads Replacement.
2. Measure remaining brake pad thickness at several points, using the CH-230-A - disc gauge (1).
3. Compare brake pad thickness to disc brake component specifications.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.