Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CORVETTE V8-6.2LREPAIR AND DIAGNOSISLIGHTING AND HORNSTURN SIGNALSTURN SIGNAL SWITCHSERVICE AND REPAIRTURN SIGNAL SWITCH BRACKET REPLACEMENT
2012 Chevrolet Corvette V8-6.2L
Turn Signal Switch Bracket Replacement
2012 Chevrolet Corvette V8-6.2LSECTION Turn Signal Switch Bracket Replacement
Turn Signal Switch Bracket Replacement
Removal Procedure
1. Remove the steering shaft upper bearing spring. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Manual) Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Manual)Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Telescoping) Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Telescoping).
2. Remove the turn signal and headlamp dimmer switch assembly. Refer to Turn Signal Multifunction Switch Replacement Turn Signal Multifunction Switch Replacement.
3. Remove the windshield wiper and windshield washer switch from the turn signal bracket. Refer to Windshield Wiper and Washer Switch Replacement Service and Repair.
4. Release the tabs retaining the turn signal switch bracket (1) to the steering column housing.
5. Slide the turn signal switch bracket (1) off of the steering column shaft.
Installation Procedure
Note: The turn signal switch bracket must be pressed firmly against the steering column housing.
1. Slide the turn signal switch bracket (1) onto the steering column shaft ensuring it is seated and the tabs have engaged the steering column housing.
2. Install the windshield wiper and washer switch assembly to the signal switch bracket. Refer to Windshield Wiper and Washer Switch Replacement Service and Repair.
3. Install the turn signal headlamp dimmer switch assembly only to the turn signal switch bracket. Refer to Turn Signal Multifunction Switch Replacement Turn Signal Multifunction Switch Replacement.
4. Install the steering shaft upper bearing spring. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Manual) Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Manual)Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Telescoping) Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Telescoping).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.