SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CORVETTE V8-6.2LREPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTRADIO, STEREO, AND COMPACT DISCTESTING AND INSPECTIONPROGRAMMING AND RELEARNINGRADIO PROGRAMMING AND SETUP
2012 Chevrolet Corvette V8-6.2L

Radio Programming and Setup

2012 Chevrolet Corvette V8-6.2LSECTION Radio Programming and Setup



Radio Programming and Setup

Each of the following service procedures require programming or setup procedures to be performed on the radio.

Radio Programming and Setup

Note:
The radio setup files will configure the radio amplifier (if equipped), internal equalization settings, and program the vehicle identification number (VIN). Without the following setup procedure, the sound quality and volume of the radio may be degraded.

For Navigation radios, setup is completed using the scan tool and the VIN relearn procedure.

If exchanging the same radio, from one vehicle to another, the VIN from the vehicle receiving the radio needs to be programmed with the scan tool.

For the base radio, use the Radio Setup procedure available in Module Setup menu of the scan tool. After programming cycle the ignition key with the retained accessory power (RAP) disabled.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.