Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CORVETTE V8-6.2L SCREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINMANUAL TRANSMISSION/TRANSAXLETRANSMISSION TEMPERATURE SENSOR/SWITCHSERVICE AND REPAIR
2012 Chevrolet Corvette V8-6.2L SC
Transmission Temperature Sensor/Switch: Service and Repair
2012 Chevrolet Corvette V8-6.2L SCSECTION Service and Repair
Transmission Fluid Temperature Sensor Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Disconnect the transmission fluid temperature sensor electrical connector.
3. Remove the transmission fluid temperature sensor.
Installation Procedure
Caution:
Refer to Fastener Caution Fastener Caution.
1. Install the transmission fluid temperature sensor.
Tighten the transmission fluid temperature sensor to 27 Nm (20 lb ft).
2. Connect the transmission fluid temperature sensor electrical connector.
3. Add the transmission fluid. Refer to Transmission Fluid Level Inspection Testing and Inspection.
4. Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.