Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CORVETTE V8-6.2L SCREPAIR AND DIAGNOSISLIGHTING AND HORNSCARGO LAMPSERVICE AND REPAIRCARGO LAMP REPLACEMENT
2012 Chevrolet Corvette V8-6.2L SC
Cargo Lamp Replacement
2012 Chevrolet Corvette V8-6.2L SCSECTION Cargo Lamp Replacement
Cargo Lamp Replacement
Removal Procedure
1. Open the rear lift window (coupe), or open the trunk lid.
2. Remove the cargo lamp assembly from the cargo area corner carpet section.
Slide the lamp up out of the carpet panel.
Installation Procedure
1. Install the cargo lamp assembly to the cargo area corner carpet section.
Snap the lamp into the carpet panel.
2. Close the rear lift window (coupe), or close the trunk lid.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.