Ignition Lock Key Transmitter Antenna Replacement - Right Side

2012 Chevrolet Corvette V8-6.2L SCSECTION Ignition Lock Key Transmitter Antenna Replacement - Right Side



Ignition Lock Key Transmitter Antenna Replacement - Right Side

Removal Procedure

1. Remove the rear wheel (passenger side). Refer to Tire and Wheel Removal and Installation Service and Repair.

2. Remove the rear wheel liner (passenger side). Refer to Rear Wheelhouse Panel Liner Replacement .

3. Disconnect the electrical connector.





4. Pull on the antenna to disengage the antenna from the retaining bracket.

Installation Procedure





1. Push on the antenna to engage the antenna to the retaining bracket.

2. Connect the antenna wire lead to the antenna.

3. Install the rear wheel liner. Refer to Rear Wheelhouse Panel Liner Replacement .

4. Install the rear wheel. Refer to Tire and Wheel Removal and Installation Service and Repair.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.