Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CORVETTE V8-6.2L SCREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYANTENNA - KEYLESS ENTRYSERVICE AND REPAIRIGNITION LOCK KEY TRANSMITTER ANTENNA REPLACEMENT - REAR COMPARTMENT
2012 Chevrolet Corvette V8-6.2L SC
Ignition Lock Key Transmitter Antenna Replacement - Rear Compartment
2012 Chevrolet Corvette V8-6.2L SCSECTION Ignition Lock Key Transmitter Antenna Replacement - Rear Compartment
Ignition Lock Key Transmitter Antenna Replacement - Rear Compartment
Removal Procedure
1. Open the rear compartment.
2. Remove the center trim panel carpet. Refer to Rear Compartment Rear Center Trim Panel Carpet Replacement Rear Compartment Rear Center Trim Panel Carpet Replacement.
3. Disconnect the wire lead from the transmitter antenna.
4. Pull on the antenna to disengage the antenna from the retaining bracket.
Installation Procedure
1. Push on the antenna to engage the antenna to the retaining bracket.
2. Connect the wire lead to the transmitter antenna.
3. Install the center trim panel carpet. Refer to Rear Compartment Rear Center Trim Panel Carpet Replacement Rear Compartment Rear Center Trim Panel Carpet Replacement.
4. Close the rear compartment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.