Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012COLORADO 4WD L5-3.7LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWINDSHIELD WASHER PUMPSERVICE AND REPAIR
2012 Chevrolet Colorado 4WD L5-3.7L
Windshield Washer Pump: Service and Repair
2012 Chevrolet Colorado 4WD L5-3.7LSECTION Service and Repair
Washer Pump Replacement (2nd Design)
Removal Procedure
1. Raise and support the hood.
2. Remove the washer solvent container. Refer to Windshield Washer Solvent Container Replacement Service and Repair.
3. Pull the top of the pump outward in order to release the pump from the container.
4. Using 2 flat-bladed tools under the pump, gently pry in opposite directions in order to release the pump from the grommet.
5. Remove the washer pump (1) from the washer container.
6. Discard the washer pump grommet.
Installation Procedure
1. Install the new washer pump (1) and grommet into the washer solvent container.
2. Use clean washer solvent on the washer pump in order to aid in the installation of the new washer pump into the grommet.
3. Apply downward pressure onto the pump in order to seat the pump to the grommet.
4. Secure the top of the pump to the washer container.
5. Install the washer solvent container. Refer to Windshield Washer Solvent Container Replacement Service and Repair.
6. Close the hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.