Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012COLORADO 4WD L5-3.7LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWINDSHIELD WASHER HOSESERVICE AND REPAIR
2012 Chevrolet Colorado 4WD L5-3.7L
Windshield Washer Hose: Service and Repair
2012 Chevrolet Colorado 4WD L5-3.7LSECTION Service and Repair
Windshield Washer Hose Replacement
Removal Procedure
1. Raise and support the hood.
2. Remove the washer hose from the nozzles. Refer to Washer Nozzle Replacement Service and Repair.
3. Remove the hose from the air inlet panel.
4. Disconnect the hose (1) from the washer pump.
5. Install a cap on the washer pump outlet in order to prevent excessive washer solvent loss.
6. Remove the washer hose from the vehicle.
Installation Procedure
1. Position the new hose to the vehicle.
2. Remove the cap from the washer pump outlet and install the new hose to the outlet of the pump.
3. Position the hose (1) to the air inlet panel (4).
4. Secure the hose to the air inlet grille panel.
5. Connect the hose to the washer nozzles. Refer to Washer Nozzle Replacement Service and Repair.
6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement Service and Repair.
7. Top off the washer solvent container with washer solvent.
8. Close the hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.