Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012COLORADO 4WD L5-3.7LREPAIR AND DIAGNOSISLIGHTING AND HORNSLICENSE PLATE LAMPSERVICE AND REPAIR
2012 Chevrolet Colorado 4WD L5-3.7L
License Plate Lamp: Service and Repair
2012 Chevrolet Colorado 4WD L5-3.7LSECTION Service and Repair
Rear License Plate Lamp Bulb Replacement
Removal Procedure
1. Ensure the headlamp switch is in the OFF position.
2. Disconnect the electrical connector (2) from the license lamp assembly (1).
3. Remove the nut (3) retaining the license lamp to the bumper.
4. Remove the license lamp assembly from the bumper.
5. Twist the lamp socket counterclockwise to remove.
6. Remove the bulb.
Installation Procedure
1. Install the bulb to the lamp socket.
2. Twist the lamp socket clockwise to install.
3. Install the lamp assembly (1) into the bumper.
Caution: Refer to Fastener Caution Fastener Caution.
4. Install the license lamp nut (3).
Tighten the nut to 2.5 Nm (22 lb in).
5. Install the electrical connector (2).
6. Inspect the lamp operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.