Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012COLORADO 4WD L5-3.7LREPAIR AND DIAGNOSISLIGHTING AND HORNSDOME LAMPSERVICE AND REPAIR
2012 Chevrolet Colorado 4WD L5-3.7L
Dome Lamp: Service and Repair
2012 Chevrolet Colorado 4WD L5-3.7LSECTION Service and Repair
Dome Lamp Replacement
Removal Procedure
1. Remove the lens from the dome lamp.
2. Carefully use a flat-bladed tool, and release the tabs (2) retaining to the dome lamp to the headliner.
3. Lower the dome lamp and disconnect the electrical connector (1).
4. Remove the dome lamp from the vehicle.
Installation Procedure
1. Position the dome lamp to the headliner and connect the electrical connector (1).
2. Ensure the retaining tabs (2) are in the open position.
3. Install the dome lamp into the headliner opening and close the retaining tabs (2).
4. Ensure the dome lamp is secure to the headliner.
5. Install the lens to the dome lamp.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.