Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012COLORADO 2WD L4-2.9LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINESERVICE PRECAUTIONSREPLACING ENGINE GASKETS
2012 Chevrolet Colorado 2WD L4-2.9L
Replacing Engine Gaskets
2012 Chevrolet Colorado 2WD L4-2.9LSECTION Replacing Engine Gaskets
Replacing Engine Gaskets
1. Do not reuse any gasket unless otherwise specified. Reusable gaskets will be identified in the service procedure. Do not apply sealant to any gasket or sealing surface unless called out in the service procedure.
2. Use jack screws to separate components.
Important: Do not use any other method or technique in order to remove the gasket material from a components.
Do not use the following items in order to clean the gasket surfaces:
* Abrasive pads
* Sand paper
* Power tools
These methods of cleaning may damage the component.
Abrasive pads also produce a fine grit that the oil filter cannot remove from the oil. This grit is abrasive and may cause internal engine damage.
3. Remove all of the gasket and the sealing material from the component using a plastic or a wood scraper. Do not gouge or scrape the sealing surfaces.
Important: Do not allow the sealant to enter any blind threaded holes. The sealant may cause the following conditions:
* Prevent you from properly seating the bolt
* Cause damage when you tighten the bolt
4. When assembling components, use only the sealant specified in the service procedure. Ensure that the sealing surfaces are clean and free of debris or oil. When applying sealant to a component, apply a bead size as specified in the service procedure.
5. Tighten the bolts to the specifications.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.