Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012COLORADO 2WD L4-2.9LREPAIR AND DIAGNOSISBODY AND FRAMESEATSSERVICE AND REPAIRSPLIT BENCH SEAT REPLACEMENT
2012 Chevrolet Colorado 2WD L4-2.9L
Split Bench Seat Replacement
2012 Chevrolet Colorado 2WD L4-2.9LSECTION Split Bench Seat Replacement
Split Bench Seat Replacement
Removal Procedure
Note: If removing both front power seats, remove the passenger seat first. Power to the passenger seat is terminated once the driver seat is disconnected.
1. Ensure that the seat is all the way rearward.
2. Remove the front bolts.
3. Ensure that the seat is all the way forward.
4. Remove the rear bolts.
5. Disconnect the seat electrical connectors to the body harness.
6. Remove the seat from the vehicle.
Installation Procedure
1. Position the seat in the vehicle.
2. Connect the seat electrical connectors to the body harness.
3. Install the rear bolts.
4. Ensure that the seat is all the way rearward.
Caution: Refer to Fastener Caution Fastener Caution.
Note: After installation of a manual seat, move your body around in the seat to insure that the manual seat adjuster positively locks into position.
5. Install the front bolts. Tighten the front seat mounting bolts to 52.5 Nm (39 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.