Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2012CAMARO V8-6.2LREPAIR AND DIAGNOSISMAINTENANCEFLUIDSFLUID - DIFFERENTIALSERVICE AND REPAIRPROCEDURES
2012 Chevrolet Camaro V8-6.2L
Procedures
2012 Chevrolet Camaro V8-6.2LSECTION Procedures
Rear Axle Lubricant Level Inspection
Inspection Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.
2. Clean any dirt from around the differential fill plug (1).
3. Remove the fill plug (1) from the differential.
4. Check the differential fluid level, it should be even with the bottom of the fill plug hole to no lower than 6 mm (0.25 in) below the opening.
5. Add new fluid if necessary.
Caution:
Refer to Fastener Caution Fastener Caution.
6. Install the differential fill plug (1) to the differential and tighten to 33 Nm (24 lb ft).
7. Remove the support and lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.