SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TRAVERSE FWD V6-3.6LREPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINFLEX PLATESERVICE AND REPAIR
2011 Chevrolet Traverse FWD V6-3.6L

Flex Plate: Service and Repair

2011 Chevrolet Traverse FWD V6-3.6LSECTION Service and Repair



Engine Flywheel Replacement

Removal Procedure




1. Remove the transmission. Refer to Transmission Replacement Transmission Replacement.
2. Remove the engine flywheel bolts and flywheel. Refer to Engine Flywheel Removal (11. Engine Flywheel Removal).
3. Clean and inspect the flywheel. Refer to Engine Flywheel Cleaning and Inspection (54. Engine Flywheel Cleaning and Inspection). If the flywheel teeth are damaged, inspect the starter for proper operation. Replace the starter if you find excessive wear or damage to the starter drive. Refer to Starter Replacement (Service and Repair).

Installation Procedure




1. Install the engine flywheel and bolts. Refer to Engine Flywheel Installation (131. Engine Flywheel Installation).
2. Install the transmission. Refer to Transmission Replacement Transmission Replacement.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.