Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSENSORS AND SWITCHES - COMPUTERS AND CONTROL SYSTEMSOIL PRESSURE SENSORSERVICE AND REPAIR
2011 Chevrolet Traverse AWD V6-3.6L
Oil Pressure Sensor: Service and Repair
2011 Chevrolet Traverse AWD V6-3.6LSECTION Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Special Tools
J 41712 Oil Pressure Switch Socket
Removal Procedure
1. Turn the ignition OFF.
2. Disconnect the oil pressure sensor electrical connector.
3. Remove the oil pressure sensor (1).
Installation Procedure
Caution: Refer to Fastener Caution (Fastener Caution).
1. Install the oil pressure sensor (1).
Tighten the oil pressure sensor to 20 Nm (15 lb ft).
2. Connect the oil pressure sensor electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.