Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSENSORS AND SWITCHES - COMPUTERS AND CONTROL SYSTEMSCRANKSHAFT POSITION SENSORLOCATIONS
2011 Chevrolet Traverse AWD V6-3.6L
Crankshaft Position Sensor: Locations
2011 Chevrolet Traverse AWD V6-3.6LSECTION Locations
Powertrain Component Views
Engine Components - Right Rear
1 - Ignition Coil 5
2 - Ignition Coil 3
3 - Ignition Coil 1
4 - Throttle Body
5 - Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
6 - Engine Control Module (ECM)
7 - Brake Booster Pump - Auxiliary
8 - Fuse Block - Underhood
9 - Camshaft Position (CMP) Actuator Solenoid - Bank 2 Intake
10 - Camshaft Position (CMP) Actuator Solenoid - Bank 2 Exhaust
11 - Wheel Speed Sensor (WSS) - Right Front Connector
12 - Camshaft Position (CMP) Sensor - Bank 1 Intake
13 - Camshaft Position (CMP) Actuator Solenoid - Bank 1 Intake
14 - Camshaft Position (CMP) Actuator Solenoid - Bank 1 Exhaust
15 - Camshaft Position (CMP) Sensor - Bank 1 Exhaust
16 - Heated Oxygen Sensor (HO2S) Bank 1 Sensor 2 Connector
17 - Knock Sensor (KS) 1
18 - Crankshaft Position (CKP) Sensor
19 - Heated Oxygen Sensor (HO2S) Bank 1 Sensor 1
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.