Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TRAVERSE AWD V6-3.6LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTCOOLING SYSTEMRADIATORSERVICE AND REPAIRPROCEDURES
2011 Chevrolet Traverse AWD V6-3.6L
Procedures
2011 Chevrolet Traverse AWD V6-3.6LSECTION Procedures
Radiator Cleaning
Warning
NEVER spray water on a hot heat exchanger. The resulting steam could cause personal injury.
Caution: The heat exchanger fins are necessary for good heat transfer. Do not brush the fins. This may cause damage to the fins, reducing heat transfer.
Note: Remove bugs, leaves, dirt and other debris by blowing compressed air through the engine side of the radiator.
* Some conditions may require the use of warm water and a mild detergent.
* Clean the A/C condenser fins.
* Clean between the A/C condenser and radiator.
* Clean the radiator cooling fins.
* Straighten any damaged cooling fins.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.