Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011TAHOE 2WD V8-6.0L HYBRIDREPAIR AND DIAGNOSISDIAGRAMSEXPLODED VIEWSAUTOMATIC TRANSMISSION/TRANSAXLE2ML70 - AUTOMATIC TRANSMISSIONDISASSEMBLED VIEWSA/TRANS REAR CASE ASSEMBLY COMPONENTS
2011 Chevrolet Tahoe 2WD V8-6.0L Hybrid
A/Trans Rear Case Assembly Components
2011 Chevrolet Tahoe 2WD V8-6.0L HybridSECTION A/Trans Rear Case Assembly Components
Disassembled Views
A/Trans Rear Case Assembly Components
425 - Hybrid Low, 1-2 Clutch Piston Retaining Ring
426 - Hybrid Low, 1-2 Clutch Backing Plate Assembly
427 - Hybrid Low, 1-2 Clutch Plate Assembly
428 - Hybrid Low, 1-2 Clutch Plate
429 - Hybrid Low, 1-2 Clutch Plate - Waved
430 - Hybrid Low, 1-2 Clutch Return Spring Assembly
431 - Hybrid Low, 1-2 Clutch Piston
432 - Internal Gear - 3rd Position
433 - Internal Gear Thrust Washer - 3rd Position - Steel
434 - Sun Gear Carrier Assembly - 3rd Position
435 - Internal Gear Thrust Bearing Assembly - 2nd Position
436 - Hybrid Direct, 2-3-4 Clutch Hub
437 - Output Shaft Thrust Bearing Assembly
438 - Output Shaft Retaining Ring
439 - Output Shaft Assembly
440 - Hybrid Direct, 2-3-4 Clutch Housing Assembly
441 - Hybrid Direct, 2-3-4 Clutch Housing Thrust Bearing Assembly
442 - Hybrid Direct, 2-3-4 Clutch Housing Seal Ring
443 - Hybrid Direct, 2-3-4 Clutch Support Bolt
444 - Hybrid Direct, 2-3-4 Clutch Support Assembly
445 - Hybrid Direct, 2-3-4 Clutch Support Gasket
446 - Vehicle Speed Sensor Bolt
447 - A/Trans Output Speed Sensor Assembly
448 - A/Trans Output Speed Sensor O-Ring Seal
449 - A/Trans Rear Case Assembly
450 - Park Pawl Shaft
451 - Park Pawl Shaft Hole Plug
452 - Park Pawl Cover Gasket
453 - Park Pawl Cover
454 - Park Pawl Cover Bolt
455 - Park Pawl Actuator Guide Pin
456 - Park Pawl Actuator Guide
457 - Park Pawl Spring
458 - Park Pawl
459 - Internal Gear Thrust Washer - 3rd Position - Plastic
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.