Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011SILVERADO 3500 4WD V8-6.0LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCOOLANT TEMPERATURE SENSOR/SWITCH (FOR COMPUTER)SERVICE AND REPAIR
2011 Chevrolet Silverado 3500 4WD V8-6.0L
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
2011 Chevrolet Silverado 3500 4WD V8-6.0LSECTION Service and Repair
Engine Coolant Temperature Sensor Replacement
Removal Procedure
Caution: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
1. Drain the cooling system to a level below the engine cooling temperature (ECT) sensor. Refer to Cooling System Draining and Filling (Vac-N-Fill) (Service and Repair)Cooling System Draining and Filling (Static Fill) (Service and Repair)Cooling System Draining and Filling (Static Fill LGH, LML) (Service and Repair).
2. Disconnect the engine wiring harness electrical connector (2) from the ECT sensor.
3. Remove the ECT sensor.
Installation Procedure
Caution: Do not insert any tools into the throttle body bore in order to avoid damage to the throttle valve plate.
Caution: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
1. If installing the old sensor, coat the threads with sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent.
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the ECT sensor and tighten to 20 Nm (15 lb ft).
3. Connect the engine wiring harness electrical connector (2) to the ECT sensor.
4. Refill the cooling. Refer to Cooling System Draining and Filling (Vac-N-Fill) (Service and Repair)Cooling System Draining and Filling (Static Fill) (Service and Repair)Cooling System Draining and Filling (Static Fill LGH, LML) (Service and Repair).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.