Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011SILVERADO 1500 4WD V8-6.2LREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTIGNITION SYSTEMSPARK PLUGSERVICE AND REPAIR
2011 Chevrolet Silverado 1500 4WD V8-6.2L
Spark Plug: Service and Repair
2011 Chevrolet Silverado 1500 4WD V8-6.2LSECTION Service and Repair
Spark Plug Replacement
Removal Procedure
1. Remove the spark plug wire from the spark plug.
1. Twist the spark plug wire boot a 1/2 turn.
2. Pull only on the boot in order to remove the wire from the spark plug.
2. Brush or using compressed air, blow away any dirt from around the spark plug.
3. Remove the spark plug.
If removing more than one plug, place each plug in a tray marked with the corresponding cylinder number.
Installation Procedure
1. Inspect the spark plug gap. Adjust the gap as needed. Refer to Ignition System Specifications (Specifications).
2. Hand start the spark plug in the corresponding cylinder.
Caution: Refer to Fastener Caution (Fastener Caution).
3. Tighten the spark plug to 15 Nm (11 lb ft).
4. Install the spark plug wire to the spark plug.
5. Inspect the spark plug wire for proper installation:
1. Push sideways on each boot in order to inspect the seating.
2. Reinstall any loose boot.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.