Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011IMPALA V6-3.5LREPAIR AND DIAGNOSISENGINE, COOLING AND EXHAUSTENGINECYLINDER BLOCK ASSEMBLYENGINE BLOCK HEATERSERVICE AND REPAIRCOOLANT HEATER REPLACEMENT
2011 Chevrolet Impala V6-3.5L
Coolant Heater Replacement
2011 Chevrolet Impala V6-3.5LSECTION Coolant Heater Replacement
Coolant Heater Replacement (LGD/LZE)
Removal Procedure
1. Drain the cooling system. Refer to Cooling System Draining and Filling (9C1, 9C3 Static Fill) (9C1, 9C3 Static Fill)Cooling System Draining and Filling (LZE, LGD Static Fill) (Static Fill)Cooling System Draining and Filling (LZE, LGD GE47716 Fill) (GE47716 Fill).
2. Disconnect the engine coolant heater cord (2) from the engine coolant heater.
3. Remove the engine coolant heater.
4. Clean the engine coolant heater opening.
Installation Procedure
1. Apply sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the threads of the engine coolant heater, if necessary.
Caution: Refer to Fastener Caution (Fastener Caution).
2. Install the engine coolant heater.
Tighten the coolant heater to 60 Nm (44 lb ft).
3. Connect the engine coolant heater cord (2) to the engine coolant heater.
4. Lower the vehicle.
5. Fill the cooling system. Refer to Cooling System Draining and Filling (9C1, 9C3 Static Fill) (9C1, 9C3 Static Fill)Cooling System Draining and Filling (LZE, LGD Static Fill) (Static Fill)Cooling System Draining and Filling (LZE, LGD GE47716 Fill) (GE47716 Fill).
6. Inspect for leaks.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.