Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011HHR L4-2.4LREPAIR AND DIAGNOSISTESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSCONNECTOR REPAIRSTYCO/AMP CONNECTORS
2011 Chevrolet HHR L4-2.4L
Tyco/AMP Connectors
2011 Chevrolet HHR L4-2.4LSECTION Tyco/AMP Connectors
Tyco/AMP Connectors
Special Tools
* EL-38125-550 - Terminal Release Tool Kit
* J-38125-11A - Terminal Release Tool
* J-38125-215A - Terminal Release Tool
* J-38125-580 - Terminal Repair Kit
For equivalent regional tools, refer to Special Tools (Tools and Equipment).
Removal Procedure
1. Using your thumbs press down and slide the red CPA away from the connector lever.
2. Using your thumb press down on the locking tab and move the lever to the released position.
3. Using terminal tool J-38125-11A or equivalent, release the wire dress cover locking tabs.
4. Pivot connector wire dress cover while removing from the connector body.
5. Using terminal tool J-38125-11A or equivalent, remove the TPA by lifting straight off the connector body.
6. Using terminal release tool J-38125-215A, place the tip of the tool on the outside edge next to the terminal and depress the lock tab and remove the rear of the connector body.
Terminal Repair Procedure
Use the appropriate terminal and crimper in the J-38125 in order to replace the terminal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.