Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Crankshaft Position Sensor: Service and Repair
2011 Chevrolet HHR L4-2.2LSECTION Service and Repair
Crankshaft Position Sensor Replacement
Removal Procedure
1. Remove the starter. Refer to Starter Replacement (Service and Repair).
2. Disconnect the crankshaft position (CKP) sensor electrical connector (4).
3. Remove the CKP sensor bolt.
4. Remove the CKP sensor.
Installation Procedure
1. Lubricate the CKP sensor O-ring seal with clean engine oil.
2. Install the CKP sensor.
Caution: Refer to Fastener Caution (Fastener Caution).
3. Install the CKP sensor bolt.
Tighten the sensor bolt to 10 Nm (89 lb in).
4. Connect the CKP sensor electrical connector (4).
5. Install the starter. Refer to Starter Replacement (Service and Repair).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.