Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011HHR L4-2.2LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLANTILOCK BRAKES / TRACTION CONTROL SYSTEMSWHEEL SPEED SENSORSERVICE AND REPAIR
2011 Chevrolet HHR L4-2.2L
Wheel Speed Sensor: Service and Repair
2011 Chevrolet HHR L4-2.2LSECTION Service and Repair
Front Wheel Speed Sensor Replacement
Removal Procedure
1. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
2. Disconnect the vehicle speed sensor (VSS) electrical connector (2).
3. Remove the retainer bolt.
4. Remove the retainer.
5. Remove the VSS.
6. Remove and discard the O-ring.
Installation Procedure
1. Lubricate a new O-ring with transmission fluid. Refer to Adhesives, Fluids, Lubricants, and Sealers (Fluid Type Specifications).
2. Install the new O-ring.
3. Install the VSS assembly.
Caution: Refer to Fastener Caution (Fastener Caution).
4. Install the VSS retainer bolt.
Tighten the bolt to 9 Nm (80 lb in).
5. Connect the VSS connector to the VSS (2).
6. Install the left front wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.