Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011CORVETTE V8-7.0LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWINDSHIELD WASHER SWITCHSERVICE AND REPAIR
2011 Chevrolet Corvette V8-7.0L
Windshield Washer Switch: Service and Repair
2011 Chevrolet Corvette V8-7.0LSECTION Service and Repair
Windshield Wiper and Washer Switch Replacement
Removal Procedure
1. Remove the tilt wheel lever (4). Refer to Steering Column Tilt Wheel Release Lever Replacement (Steering Column Tilt Wheel Release Lever Replacement).
2. Remove the driver knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).
3. Separate and remove the upper (1) and the lower (3) steering column covers.
4. Disconnect the electrical connector from the wiring harness.
5. Release the upper and lower retaining clips and slide the wiper/washer switch from the steering column lock module.
Installation Procedure
1. Slide the wiper/washer switch into the steering column lock module until the upper and lower retaining clips snap into place.
2. Connect the electrical connector into the wiring harness.
3. Install the upper (1) and the lower (3) steering column covers.
4. Install the tilt wheel lever (4). Refer to Steering Column Tilt Wheel Release Lever Replacement (Steering Column Tilt Wheel Release Lever Replacement).
5. Install the driver knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement (Service and Repair).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.