Ambient Temperature Sensor / Switch HVAC: Locations

2011 Chevrolet Corvette V8-7.0LSECTION Locations



Front of Vehicle/Engine Compartment Component Views

Engine Compartment HVAC Components




1 - Surge Tank
2 - Ambient Air Temperature Sensor
3 - A/C Compressor Clutch
4 - A/C Refrigerant Pressure Sensor
5 - Engine Control Module (ECM)




Instrument Panel/Center Console Component Views

Left Side of Instrument Panel Components




1 - Brake Pedal Position (BPP) Sensor
2 - Accelerator Pedal Position (APP) Sensor
3 - Sunload Sensor
4 - Windshield Wiper/Washer Switch
5 - Turn Signal/Multifunction Switch
6 - Clutch Pedal Position (CPP) Sensor (MM6/MZ6/MN6)




Instrument Panel/Center Console Component Views

Instrument Panel and Center Console Components




1 - Head Up Display (HUD) Switch (UV6)
2 - Instrument Panel Cluster (IPC)
3 - Head Up Display (HUD) (UV6)
4 - Driver Information Center (DIC) Switch
5 - Sunload Sensor
6 - Hazard Warning Switch
7 - Radio
8 - HVAC Control Module
9 - Inflatable Restraint I/P Module
10 - Auxiliary Audio Jack (U3U)
11 - I/P Compartment Lamp
12 - Heated Seat Switch - Passenger (KA1)
13 - Suspension Control Switch (F55)
14 - Accessory Power Outlet
15 - Traction Control Switch (TCS)
16 - Cigar Lighter
17 - Heated Seat Switch - Driver (KA1)
18 - Noise Compensation Microphone (U65)
19 - Ignition Mode Switch
20 - Air Temperature Sensor - Inside
21 - Inflatable Restraint Steering Wheel Module
22 - Rear Compartment Lid Release Switch - Interior
23 - Fuel Door Release Switch
24 - I/P Dimmer Switch
25 - Folding Top Control Switch (CM7)




Front of Vehicle/Engine Compartment Component Views

Engine Compartment HVAC Components




1 - Surge Tank
2 - Ambient Air Temperature Sensor
3 - A/C Compressor Clutch
4 - A/C Refrigerant Pressure Sensor
5 - Engine Control Module (ECM)


RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.