Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011CORVETTE V8-7.0LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLRELAYS AND MODULES - BRAKES AND TRACTION CONTROLELECTRONIC BRAKE CONTROL MODULELOCATIONS
2011 Chevrolet Corvette V8-7.0L
Electronic Brake Control Module: Locations
2011 Chevrolet Corvette V8-7.0LSECTION Locations
Front of Vehicle/Engine Compartment Component Views
Brake System Components
1 - Brake Pressure Modulator Valve (BPMV)
2 - Brake Fluid Level Switch
3 - Electronic Brake Control Module (EBCM)
4 - Steering Angle Sensor
5 - Brake Pedal Position (BPP) Sensor
6 - Yaw and Lateral Accelerometer Sensor
7 - Park Brake Switch
Powertrain Component Views
Left Side of Engine Components (LS9)
1 - Fuse Block - Underhood X2
2 - Generator X1
3 - Generator X2
4 - Intake Air Temperature (IAT) Sensor 2
5 - Barometric Pressure (BARO) Sensor
6 - X149
7 - Evaporative Emission (EVAP) Canister Purge Solenoid Valve
8 - Supercharger Bypass Valve Solenoid (JL9)
9 - Manifold Absolute Pressure (MAP) Sensor
10 - X150
11 - Heated Oxygen Sensor (HO2S) - Bank 1 Sensor 1
12 - Heated Oxygen Sensor (HO2S) - Bank 1 Sensor 2
13 - Ignition Coil 7
14 - Ignition Coil 5
15 - Ignition Coil 3
16 - Ignition Coil 1
17 - Suspension Position Sensor - Left Front (FE2)
18 - Wheel Speed Sensor (WSS) - Left Front
19 - Engine Coolant Temperature (ECT) Sensor
20 - Camshaft Position (CMP) Sensor
21 - Electronic Brake Control Module (EBCM)
22 - Variable Effort Steering Actuator
23 - Throttle Body
24 - Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
25 - Knock Sensor (KS)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.