Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2011COLORADO 2WD L4-2.9LREPAIR AND DIAGNOSISBODY AND FRAMEFRAMESKID PLATESERVICE AND REPAIR
2011 Chevrolet Colorado 2WD L4-2.9L
Skid Plate: Service and Repair
2011 Chevrolet Colorado 2WD L4-2.9LSECTION Service and Repair
Engine Protection Shield Replacement
Removal Procedure
1.Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2.Remove the front shield fastener (1, 2).
3.Remove the front shield from the vehicle.
4.Remove the rear shield fastener (1, 2).
5.Remove the rear shield from the vehicle.
Installation Procedure
1.Install the rear shield to the vehicle.
Caution:Refer to Fastener Caution .
2.Install the rear shield fastener (1) and tighten to75 N �m (55 lb ft).
3.Install the rear shield fastener (2) and tighten to20 N �m (15 lb ft).
4.Install the front shield to the vehicle.
5.Install the front shield fastener (1) and tighten to60 N �m (44 lb ft).
6.Install the front shield fastener (2) and tighten to20 N �m (15 lb ft).
7.Lower the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.