Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010TAHOE 4WD V8-6.0L HYBRIDREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSVEHICLE SPEED SENSORLOCATIONS
2010 Chevrolet Tahoe 4WD V8-6.0L Hybrid
Vehicle Speed Sensor: Locations
2010 Chevrolet Tahoe 4WD V8-6.0L HybridSECTION Locations
Powertrain Component Views
Transmission and Transfer Case Components (HP2)
1 - Vehicle Speed Sensor (VSS) (without NQH)
2 - Vehicle Speed Sensor (VSS) (NQH)
3 - Transfer Case Encoder Motor (NQH)
4 - Transfer Case 2/4 Wheel Drive Actuator Position Sensor (NQH)
5 - Transmission Power Inverter Module (3 Phase) Cable Cover
Transmission Interior Components (M30)
36 - Vehicle Speed Sensor (VSS)
66 - Torque Converter Clutch (TCC) Solenoid Valve
69 - Automatic Transmission Fluid Pressure Manual Valve Position Switch
250 - Automatic Transmission Input Shaft Speed (ISS) Sensor
367a - Shift Solenoid (SS) Valve 1
367b - Shift Solenoid (SS) Valve 2
377 - Pressure Control (PC) Solenoid Valve
396 - Torque Converter Clutch (TCC) Pulse Width Modulation (PWM) Solenoid Valve
Transmission Interior Components (MYC or MYD)
1 - Control Solenoid Valve Assembly
2 - Automatic Transmission Input Shaft Speed (ISS) Sensor/Automatic Transmission Output Shaft (OSS) Speed Sensor
3 - Automatic Transmission Internal Mode Switch (IMS)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.