Fuel Tank Pressure Sensor: Locations

2010 Chevrolet Tahoe 4WD V8-6.0L HybridSECTION Locations



Wheels/Vehicle Underbody Component Views

Underbody Fuel System Components (Short Wheel Base without HP2)




1 - Fuel Pump and Sender Assembly - Front
2 - Fuel Tank Pressure (FTP) Sensor (except HP2)
3 - Evaporative Emissions (EVAP) Canister
4 - Evaporative Emissions (EVAP) Canister Vent Solenoid Valve

Rear Suspension and Fuel System Components




1 - Trailer Brake Control Relay (JL1)
2 - Fuel Pump Flow Control Module (HP2)/Fuel Pump/Trailer Brake Control Module (20 Series with JL1)
1 - Electronic Brake Control Module (EBCM)
4 - Suspension Position Sensor - Right Rear
5 - Shock Absorber Actuator - Right Rear (Z55)
6 - Electronic Suspension Control (ESC) Module (SWB)
7 - Automatic Level Control (ALC) Compressor (Z55)
8 - Shock Absorber Actuator - Left Rear (Z55)
9 - Suspension Position Sensor - Left Rear
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.