Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010MALIBU L4-2.4L HYBRIDREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSENGINECONNECTING ROD, ENGINE
2010 Chevrolet Malibu L4-2.4L Hybrid
Connecting Rod, Engine
2010 Chevrolet Malibu L4-2.4L HybridSECTION Connecting Rod, Engine
Connecting Rod Bolt
First Pass 25 Nm (18 lb ft)
Final Pass 100 degrees
Connecting Rod Bore Diameter - Bearing End 52.118-52.134 mm (2.0519-2.05252 in)
Connecting Rod Side Clearance 0.070-0.370 mm (0.0028-0.0146 in)
First Pass 25 Nm (18 lb ft)
Final Pass 100 degrees
Connecting Rod Bore Diameter - Bearing End 52.118-52.134 mm (2.0519-2.05252 in)
Connecting Rod Side Clearance 0.070-0.370 mm (0.0028-0.0146 in)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.