Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010MALIBU L4-2.4L HYBRIDREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSCAMSHAFT POSITION SENSORSERVICE AND REPAIRCAMSHAFT POSITION SENSOR REPLACEMENT - INTAKE
2010 Chevrolet Malibu L4-2.4L Hybrid
Camshaft Position Sensor Replacement - Intake
2010 Chevrolet Malibu L4-2.4L HybridSECTION Camshaft Position Sensor Replacement - Intake
Camshaft Position Sensor Replacement - Intake
Removal Procedure
1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement ().
2. Disconnect the engine wiring harness electrical connector (7) from the intake camshaft position (CMP) sensor (6).
3. Remove the CMP sensor bolt.
4. Remove the CMP sensor.
Installation Procedure
Note: Inspect the CMP sensor for damage, replace as necessary.
1. Lubricate the CMP sensor O-ring seal with clean engine oil.
2. Install the CMP sensor.
Caution: Refer to Fastener Caution (Fastener Caution).
3. Install the CMP sensor bolt and tighten to 10 Nm (89 lb in).
4. Connect the engine wiring harness electrical connector (7) to the intake CMP sensor (6).
5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement ().
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.