Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010HHR L4-2.4LREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING ANGLE SENSORSERVICE AND REPAIRPROCEDURES
2010 Chevrolet HHR L4-2.4L
Procedures
2010 Chevrolet HHR L4-2.4LSECTION Procedures
Steering Angle Sensor Centering
The steering angle sensor does not require centering often. Centering of the steering angle sensor might be required after certain service procedures are performed. Some of these procedures are as follows:
* Steering gear replacement
* Steering column replacement
* Steering angle sensor replacement
* Intermediate shaft replacement
* Electronic Brake Control Module (EBCM) programming or replacement
* Brake Pressure Modulator Valve Replacement
* Collision or other physical damage
1. Center the steering wheel with the wheels facing forward.
2. With a scan tool, perform the special functions steering position sensor calibration and follow the on screen instructions.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.