Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010HHR L4-2.4LREPAIR AND DIAGNOSISRELAYS AND MODULESRELAYS AND MODULES - POWER AND GROUND DISTRIBUTIONRELAY BOXLOCATIONSFUSE BLOCK - REAR ACCESS PANEL (PANEL VAN)
2010 Chevrolet HHR L4-2.4L
Fuse Block - Rear Access Panel (Panel Van)
2010 Chevrolet HHR L4-2.4LSECTION Fuse Block - Rear Access Panel (Panel Van)
Harness Routing Views
Right Rear Cargo Area (Panel Van)
1 - Wheel Well - Right Rear
2 - Fuse Block - Rear Access Panel (Panel Van)
3 - X406 (Provisional Accessory Power)
4 - Fuse Holder - BCM
5 - Fuse Holder - Provisional
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.