Fluid - M/T: Testing and Inspection

2010 Chevrolet HHR L4-2.4LSECTION Testing and Inspection



Transmission Fluid Level and Condition Check

1. Remove the left front wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).

Note: Inspect the fluid level only when the engine is off. Ensure the vehicle is level. The transaxle must be cold.

2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




3. Remove the level check plug.
4. Verify that the fluid is up to the opening.
5. If no fluid is visible, add fluid until the level check opening begins to leak fluid. Refer to Lubrication Specifications (Fluid Type Specifications) for fluid recommendations.

Caution: Refer to Fastener Caution (Fastener Caution).

6. Install the fluid level check plug.

Tighten the fluid level check plug to 38 Nm (28 lb ft).

7. Install the left front wheel. Refer to Tire and Wheel Removal and Installation (Service and Repair).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.