Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010HHR L4-2.2LREPAIR AND DIAGNOSISBRAKES AND TRACTION CONTROLDRUM BRAKE SYSTEMBACKING PLATESERVICE AND REPAIR
2010 Chevrolet HHR L4-2.2L
Backing Plate: Service and Repair
2010 Chevrolet HHR L4-2.2LSECTION Service and Repair
Rear Brake Backing Plate Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning (Brake Dust Warning).
1. Remove the brake shoes. Refer to Brake Shoe Replacement (Service and Repair).
2. Remove the wheel cylinder. Refer to Rear Brake Cylinder Replacement (Service and Repair).
3. Release the rear park brake cable end fitting (1) from the drum brake backing plate.
4. Remove the rear wheel bearing and hub assembly. Refer to Rear Wheel Bearing and Hub Replacement (Rear Suspension).
5. Remove the rear brake backing plate from the rear axle assembly.
Installation Procedure
1. Install the rear brake backing plate to the rear axle assembly.
2. Install the rear wheel bearing and hub assembly. Refer to Rear Wheel Bearing and Hub Replacement (Rear Suspension).
3. Install the rear park brake cable end fitting (1) to the drum brake backing plate.
4. Install the wheel cylinder. Refer to Rear Brake Cylinder Replacement (Service and Repair).
5. Install the brake shoes. Refer to Brake Shoe Replacement (Service and Repair).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.