Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010EXPRESS 2500 V8-4.8LREPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSSERVICE AND REPAIROUTER BELT SEALING STRIP REPLACEMENT
2010 Chevrolet Express 2500 V8-4.8L
Outer Belt Sealing Strip Replacement
2010 Chevrolet Express 2500 V8-4.8LSECTION Outer Belt Sealing Strip Replacement
Outer Belt Sealing Strip Replacement
Removal Procedure
1. Lower the window.
2. Tilt the top of the sealing strip away from the vehicle in an outboard direction.
3. Gently pull the sealing strip away from the pinch weld flange.
Installation Procedure
1. Spray the inside of the sealing strip with a water and soap solution.
2. Install the sealing strip to the pinch-weld flange by tilting the top edge of the sealing strip slightly outboard to ensure the pinch weld flange correctly enters the retention clips.
3. Push down on sealing strip until all clips are fully seated.
4. Raise the window.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.