Front Side Door Window Switch Replacement

2010 Chevrolet Express 2500 V8-4.8LSECTION Front Side Door Window Switch Replacement



Front Side Door Window Switch Replacement

Removal Procedure




1. Remove the front door trim plate. Refer to Front Door Trim Plate Replacement (Front Door Trim Plate Replacement).
2. Remove the electrical connector (3) from the power window switch.
3. Release the clip from the front door trim plate (1) in order to remove the escutcheon from the trim plate (1).
4. Release the tabs on the power window switch (10) in order to remove the power window switch (10) from the trim plate.

Installation Procedure




1. Install the power window switch (10) to the front door trim plate (1).
2. Push the power window switch in order to engage the retaining clip.
3. Install the electrical connector (3) to the power window switch.
4. Install the front door trim plate (1). Refer to Front Door Trim Plate Replacement (Front Door Trim Plate Replacement).

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.