Removal and Replacement

Battery Replacement (LLV/LLR) (2.9L/3.7L)

Removal Procedure

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Battery Negative Cable Disconnection and Connection).




2. Open the protective cover (3) to access the battery positive cable terminal.
3. Loosen the battery positive cable nut (4).
4. Disconnect the battery positive cable from the battery.




5. Disconnect the battery vent duct from the upper battery box (2).
6. Press the locking tabs (1) inward in order to remove the upper battery box (2) from the lower battery box (3).




7. Remove the battery retainer nut (3).
8. Remove the battery retainer (1) and washer (2).
9. Remove the battery (4) from the lower battery box (5).

Installation Procedure




1. Install the battery (4) into the lower battery box (5).
2. Install the battery retainer (1) and washer (2).

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the battery retainer nut (3) and tighten to 15 Nm (11 lb ft).




4. Install the upper battery box (2) over the battery, engage the locking tabs (1) into the lower battery box (3).
5. Connect the battery vent duct to the upper battery box (2).




6. Clean any existing corrosion from the battery terminal and battery cable using a wire brush.
7. Connect the battery positive cable to the battery and tighten the battery cable nut (4) to 9 Nm (80 lb in).
8. Close the protective cover (3) over the battery positive cable terminal.
9. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Battery Negative Cable Disconnection and Connection).