Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010COLORADO 2WD L5-3.7LREPAIR AND DIAGNOSISMAINTENANCEDRIVE BELTSERVICE AND REPAIR
2010 Chevrolet Colorado 2WD L5-3.7L
Drive Belt: Service and Repair
2010 Chevrolet Colorado 2WD L5-3.7LSECTION Service and Repair
Drive Belt Replacement
Removal Procedure
1. Install a 3/8 inch breaker bar into the drive belt tensioner (7) and rotate the tensioner (7) clockwise, enough to relieve the tension on the drive belt (1).
2. Slide the drive belt (1) from the water pump pulley (2).
3. Allow the drive belt tensioner (7) to return to the relaxed position.
4. Remove the drive belt (1) from the remaining pulleys.
Installation Procedure
1. Route the drive belt (1) over all the pulleys, excluding the water pump pulley (2).
2. Install the 3/8 inch breaker bar on the drive belt tensioner (7) and rotate the tensioner (7) clockwise.
3. Route the drive belt (1) over the top of the water pump pulley (2).
4. Slowly release the tension to the drive belt tensioner (7).
Important: Ensure the drive belt is properly aligned and seated into the grooves of the drive pulleys.
5. Inspect for proper installation of the drive belt (1) on the pulleys.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.