Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010COBALT L4-2.2LREPAIR AND DIAGNOSISBODY AND FRAMEFENDERFRONT FENDERFRONT FENDER LINERSERVICE AND REPAIR
2010 Chevrolet Cobalt L4-2.2L
Front Fender Liner: Service and Repair
2010 Chevrolet Cobalt L4-2.2LSECTION Service and Repair
Front Fender Liner Replacement
2.Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
1Front Wheelhouse Liner Retainer (Qty: 5)
2Front Wheelhouse Liner Fastener (Qty: 9)
Caution:Refer to Fastener Caution .
Tighten 2 N �m (18 lb in)
3Rocker Panel ScrewTighten 1.5 N �m (13 lb in)
4Front Fender Liner
Tip Lift the fender liner from the rocker molding.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.