Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010CAMARO V6-3.6LREPAIR AND DIAGNOSISMAINTENANCEALIGNMENTSERVICE AND REPAIRWHEEL ALIGNMENT - STEERING WHEEL ANGLE AND/OR FRONT TOE ADJUSTMENT
2010 Chevrolet Camaro V6-3.6L
Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
2010 Chevrolet Camaro V6-3.6LSECTION Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment
1. Before performing any adjustment affecting the wheel alignment, refer to Wheel Alignment Measurement (Wheel Alignment Measurement).
2. Ensure that the steering wheel is set in a straight ahead position.
3. Loosen the tie rod jam nut (5).
4. Adjust the toe to specification by turning the adjuster (6). Refer to Wheel Alignment Specifications (Wheel Alignment Specifications).
Caution: Refer to Fastener Caution (Fastener Caution).
5. Install the tie rod jam nut (5) and tighten to 68 Nm(50 lb ft).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.