Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010CAMARO V6-3.6LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGSERVICE PORT HVACSERVICE AND REPAIRAIR CONDITIONING REFRIGERANT SERVICE VALVE CORE REPLACEMENT
2010 Chevrolet Camaro V6-3.6L
Air Conditioning Refrigerant Service Valve Core Replacement
2010 Chevrolet Camaro V6-3.6LSECTION Air Conditioning Refrigerant Service Valve Core Replacement
Air Conditioning Refrigerant Service Valve Core Replacement
Special Tools
* J 39400-A - Halogen Leak Detector
* J 46246 - Valve Core Removal Tool
Removal Procedure
1. Recover the refrigerant. Refer to Refrigerant Recovery and Recharging (Refrigerant Recovery and Recharging).
2. Use J 46246 - Valve Core Removal Tool or equivalent to remove the valve core.
Installation Procedure
1. Use J 46246 - Valve Core Removal Tool or equivalent to install and tighten the valve core.
2. Evacuate and charge the A/C system. Refer to Refrigerant Recovery and Recharging (Refrigerant Recovery and Recharging).
Note: To prevent loss of refrigerant charge, tighten the cap. Replace the cap if the seal is missing or damaged.
3. Test the affected A/C fittings for leaks using J 39400-A - Halogen Leak Detector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.