Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2010CAMARO V6-3.6LREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGREFRIGERANT OILSPECIFICATIONS
2010 Chevrolet Camaro V6-3.6L
Capacity Specifications
2010 Chevrolet Camaro V6-3.6LSECTION Specifications
Refrigerant oil
Compressor Replacement
The Delphi Service Compressor CSP17 is precharged with the specified amount of PAG Oil 75 ml(1) (2.5 oz(1))
Condenser Replacement 40 ml(1) (1.35 oz(1))
Desiccant Bag Replacement 10 ml(1) (0.34 oz(1))
Evaporator Replacement 30 ml(1) (1.0 oz(1))
Refrigerant Line Replacement 10 ml(1) (0.34 oz(1))
Total System PAG Oil Capacity 120 ml (4.06 oz)
(1)If more than the specified amount of PAG oil was drained from a component, add the equal amount of oil drained.
Compressor Replacement
The Delphi Service Compressor CSP17 is precharged with the specified amount of PAG Oil 75 ml(1) (2.5 oz(1))
Condenser Replacement 40 ml(1) (1.35 oz(1))
Desiccant Bag Replacement 10 ml(1) (0.34 oz(1))
Evaporator Replacement 30 ml(1) (1.0 oz(1))
Refrigerant Line Replacement 10 ml(1) (0.34 oz(1))
Total System PAG Oil Capacity 120 ml (4.06 oz)
(1)If more than the specified amount of PAG oil was drained from a component, add the equal amount of oil drained.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.