Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2009TRAVERSE FWD V6-3.6LREPAIR AND DIAGNOSISWIPER AND WASHER SYSTEMSWIPER BLADETESTING AND INSPECTION
2009 Chevrolet Traverse FWD V6-3.6L
Wiper Blade: Testing and Inspection
2009 Chevrolet Traverse FWD V6-3.6LSECTION Testing and Inspection
Wiper Blade Element Check
1. Remove the wiper blades from the wiper arms. Refer to Windshield Wiper Blade Replacement (Acadia) (Windshield Wiper Blade Replacement)Windshield Wiper Blade Replacement (Enclave) (Windshield Wiper Blade Replacement)Windshield Wiper Blade Replacement (OUTLOOK) (Windshield Wiper Blade Replacement)Windshield Wiper Blade Replacement (Traverse) (Windshield Wiper Blade Replacement).
2. Look down the length of the blade element.
3. Replace the wiper blade element if the rubber element which contacts the glass is not on the centerline of the blade +/-15 degrees.
4. Install the wiper blades on the wiper arms. Refer to Windshield Wiper Blade Replacement (Acadia) (Windshield Wiper Blade Replacement)Windshield Wiper Blade Replacement (Enclave) (Windshield Wiper Blade Replacement)Windshield Wiper Blade Replacement (OUTLOOK) (Windshield Wiper Blade Replacement)Windshield Wiper Blade Replacement (Traverse) (Windshield Wiper Blade Replacement).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.